After using the TINY WHOOP V1 mount I found it hard to print unless you have a very high ress (20Micron) printer
This mount is modified to be stronger but still weigh 0.8 grams.
I removed some (useless) material between the 3 screw attachment legs but made the actual camera mount a bit thicker so it is easier to print at 50 or even 100 Microns but still have the same weight.
My M3D printer was set to medium-low quality with the highest infill possible in the software.
Already had allot of flights and hard crashes with it but without any breakages of the mount.
Enjoy and share your made`s please!!!
Print it directly on your bed, the part is to fragile to remove from a raft.
Weight using PLA should be around 0.8 Grams.