Tired of spilling your beer while driving around in your Subaru Impreza? This thing is for you!!
Seriously, I always end up spilling anything I put in my Impreza cup holder.. it's too big to fit normal soda cans so they always swinging around when i drive. I made up these little rings so it fits perfectly.
In my car, the front hole was a little bigger then the rear one so I made it 0.5mm bigger. I don't know if it's the case for everyone.
This should fit any Impreza 2008 to 2011 Sedan. (2.5i and WRX. Not sure about STi.Tell me if you ever try it) It could fit many Subary car between these years, i'm not sure about other models, let me know if you try.
I printed them flat in an heated bed with PLA. So 90 degrees rotation on X axis is required in slicer. DO NOT USE PLA... TESTED IT ON A HOT SUMMER DAY AND IT SHRUNK I'm gonna make them in ABS and get back with the results.