Loading
MagicEngineer

Roper

by MagicEngineer Jun 16, 2016
Download All Files

Thing Apps Enabled

Please Login to Comment

I ran into a couple of these last week!

As far as the printability, some of that comes down to the limitations of your printer, material, and how experienced you are with your combo. I doubt I'd be able to print this with the thin parts in PLA, but I'm not sure how well it works for others.

You should make a version where the tentacles are separate pieces. Then it wouldnt need to be slived in half to print. Also you could make the tentacles simple straight tapered pillars and then after they are printed they could be heated in hot water and warped to a wavy shape and glued onto the figure. Would make alot easier to print.

I have always found it easier to print with a perfectly flat bottom to each piece and a large bed surface area.