- M8 bolt
- M8 nut
- 1 cent (euro cent) coin.
- 100% infill on both parts, at least on part 2.
- 200 microns is enough, but it is better to print in 100-150.
- working even with PLA
- you can use lubricant on the rail (such as lithium grease)
All 37.5mm non-soldered intel LGA CPU are supposed to be compatible.
I can't test all CPU, but It worked so far on all generations from 775 to 1151, except 1156 that isn't tested (most of them, if not all were soldered).
Please note I am not responsible for eventual cpu destruction, or any other issue.
I share a functional and tested tool, you are responsible for what you do with.
And again, check if your cpu have internal paste or indium solder before trying to delid it !
If you have issues on sliding, be sure to remove any support trace, having your printer calibrated, and not printing too fast.
A better version, permitting relid is in progress, I'll upload it when it is finished (early 2018)