A minimal GoPro Hero 3 fixed mount for my Spyda 500 Quadcopter design.
Two version of this thing are supplied depending on which plates you printed out from the original Spyda Quad http://www.thingiverse.com/thing:160607 :
- A version for the DJI arm Plates.
- A Version for the Crossfire arm Plates
It can be mounted on the top or bottom of the plates, either way up, ground clearance allowing.
You can use the original GoPro waterproof case too, just slide the mount forward on the slots to increase the rear clearance.
The Hero 3 can be mounted either way up in the guard, the access holes are symmetrical.
Print and mount.
It should print without support but minimal bridging for holes.