Loading
windrides

GoPro Session FPV Mount v2

by windrides Jun 22, 2016
Download All Files

Thing Apps Enabled

Please Login to Comment

Hello,
This is my first time doing anything with downloading a file and printing it. Can I just put this downloaded file onto an sd card and then put that in my 3d printer?
Thanks

You need to download a Slizer like Ultimakers Cura to "slize" the file https://ultimaker.com/en/products/ultimaker-cura-software

I printed with tpu and had over 5 breaks. I could just be over stressing it but I would suggest printing in a different material. (%100 infill)

Please, I'm needing it with 12º

You can print the 15º mount and add a layer of double sided foam tape under the back side of the legs.

Will this work well with abs or tpu?

TPU will be stronger, it works with ABS too.

Hi. I have made your mount and it is very strong in petg 100% infill. I do however have a question(a rather stupid one). What holds the session into the Mount so it doesn't fall out the back. It works if my battery is behind the camera but on my stack quads, there is no battery to hold it in.

Thanks.

you can remix it adding a back support and print it in TPU allowing you to flex it and install. Le Drib uses a similar mount.

Hi, thank you very much. You need a 3mm cable tie like these: https://www.amazon.com/Zip-Ties-SODIAL-Black-Cable/dp/B01LZFX467

I printed four of these mounts. I love the mount. However, the bottom bracket where you put the strap though is way too weak and snaps easily, the bottom bracket should be one big piece, not two thin ones. Otherwise, love it.

Thank you very much. You can print it in PETG which is a lot stronger than PLA. I can modify the base brackets but it would be heavier. I tried to make it as light as possible.

If you could make one with a bigger bottom bracket, that would be awesome as the extra weight isn't too much of a concern for me. I also just had a couple printed in nylon, should be a lot stronger, guessing it will be a lot more durable ☺️