This is Syberia game themed Apple MacBook 2015 stand. The geared design will go nice with my Led bridge lamp. Later there will be nice diorama built in it.
I designed this, because when I work at the desk in my workshop,I needed a way to hold my laptop vertically to have decent WiFi signal. There I have big screen, so I don't need laptop to be open, small screen distracts me, so ... long story short - this is my solution to specifically mine setup. Others will do fine with WiFi extender or stands where screen can be held open. Relation to Syberia game happened unintentially and was realised only when design was complete.
Most parts are printed flat, except "geared top" and "arc inside", which should be printed on a side with raft.
Parts are glued together with acetone. I use small syringe with needle to spread it nicelly on the points, where parts are touchuing each other. I apply acetone two times before pressign parts together. After counting to ten, they are bonded strong enough to continue.
- Glue "tower front" and "tower back" to the "side" parts
- Glue "arc inside" part to the "side" parts
- Glue second "arc" part on top
- Finally glue "geared top" part
- Put assembly on a platform, check that it fits nicelly, gue it on.