These are a Left and Right tslot fan shroud with seats for 2 3mm led bulbs design I remixed for http://www.thingiverse.com/thing:1650591. They are a tooless option for mounting 40mm fans. Still working on clearances for the leds and the best way to route the wires out of the shroud. I am planning to run all 4 leds in parallel and connect them to the ramps board with the same pins that power the board cooling fan. I will wire both part cooling fans in parallel and have only 1 set of red/black wires going to the board. fit checked the clearances with the tslots on the carriage and there is nor problem and did not require post processing.
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.