Got a couple pounds of smoked sea salt and wanted to divvy it up among friends. Had some small ziplock bags that I wanted to fill and needed a scoop. So I modeled and printed my own. Fits the 50mm (2")-wide bags I had.
scoop_w_grip has gripper ridges for your thumb (silver scoop).
3 shells, but uses 2 mostly since it's 0.7mm thick. May need supports if you have a hard time with overhangs.
Nothing too fancy, just wanted a fairly quick scoop.
NOTE: If using PLA, best use supports unless you have really good cooling allowing for a bit of overhang. Tested using PLA with the updated version and my machine did need supports turned on.
Using my favorite drug, Onshape.