100% Printed Brush
I created this brush to clean the printer and the workbench.
The brush uses the support structure [first layer] to create the bristles.
MakaWare Version Used: 220.127.116.11
Support Structure: YES
Step1 - Print the Bristles.stl file, but stop the print after the first support layer is done [straight lines]. Carefully remove the support structure and cut it to the desire height [I used 40 mm]. You will need to repeat this print 4-5 times [takes about 3 minutes a print].
Step2 - Print the rest of the brush: Poloh.stl [Medium-Res with Support].
Step3 - Slide the Bristles [Support Structure] into the holes. Use a soldering iron, a lighter or a sufficiently hot surface to fuse the top of the bristles together. You can also simply glue the bristle tops together.
Step4 - Once the Bristles are done, seal the 2 parts of the brush together [using a soldering iron] or glue them together.
Step5 [Optional] - Slide a 3mm diameter magnet into the top of the brush. The brush will now stick to the Replicator 2's frame.