This part was designed to allow use of a fine-tipped Sharpie pen with the Cricut Explore air. It is based on the OEM Cricut pen adapter, with slight dimensional changes.
- Be sure to prime the pen (scribbling on a piece of scrap paper) before starting the job, otherwise the first few cm will not have ink (as seen in picture).
- The weight of the line can be changed by adjusting material thickness dial on the Cricut. The picture shown has the dial set to "Paper" (second thinnest).
Printed with leaf spring fingers pointing upwards. File takes ~1 hr at .3mm resolution
Some light scraping with an exacto knife may be required to clean up part.
Originally designed in Solidworks, part migrated to Fusion 360.