This is a LED strip and Video transmitter holder for the Lisam LS-180 FPV Drone.
You can find the full build guide for this drone on my blog here: https://nathan.vertile.com/blog/2016/07/07/omnibus-typhoon-miniquad/
This STL was designed for this frame: http://goo.gl/6xjXfn or this frame http://bit.ly/2rNLrFm
This video transmitter: http://goo.gl/5LjBLL
This LED strip: http://goo.gl/M2kf3m
For the VTX and Ledstrip, print in ABS with support Drill out the large holes with a 13/64" bit.
Use 2mm hex screws to attach the LED strip after drilling out with a 1/16" bit.
Secure the LED strip wiring under the mount and fasten the whole piece in place by sliding over the rear standoffs and securing with a single zip tie through the pre-existing holes in the frame.
.15mm layer height, .3mm nozzle
Flying the FPV180 miniquad with this part.