Want to live healty?
Start with the details!
Your little yellow kitchensponge propably contains more Bacteria than your hole Bathroom, but you're cleaning your dinnerplates with it!
With this little device, your sponge can dry much more easy, and this causes the Bacteria to die.
Nice sideeffect, your kitchen stays clean and dry, the water flows directly into the sink.
The pictures are of spongeholder_v1
I improved the design by adding some rips, so that the sponge also dries from the bottomside.
These rips are included into the file spongeholder_v2
I recommand to use a Brim, so that the thin frontedges stick to the bed.
Support from the printbed is needed.
For me, PLA is fine, if you use extremly hot cleaningwater of over 60°C, it could cause some trouble and you shoud switch so PETG or ABS.
Use three or more toplayers to make sure that there are no holes in the topsurface. Water could get inside and lead to mold.
100mm x 85mm x 33mm