I liked the design by kenotic and was ready to download, only to realize the newer 2016 Flashforge Creator Pro's don't have the little holes in the top corners any longer, so the design doesn't work with the newer models. I found a cool spot in the corner to mount it and remixed their design. My design makes use of the screw and hole on the left side of the Flash Forge. The stock screw is too short so you need to pick up an M4 x 16mm screw and an M4 wingnut (and M4 washer or lockwasher if you would like). Simply take out the stock screw and replace it with the new one. Place the mount over the screw and bolt on the wing nut.
I have 2 different length sizes of the mount: Tall and Tallest. Goes past the height of the motor carriage but mine has yet to be hit. Having different lengths gives you the ability to decide which version works best for you. The pics taken are using the Tall version.
The v1 cam knob is for v1 pi cameras and the v2 knob is for v2 pi cameras (unaltered and taken from kenotic and bradleyw).
Printed with ABS and 100% infill for strength.
Parts needed: M4 x 16mm screw, M4 Wingnut, M4 Washer
Comments are welcome and please share your makes!
I uploaded a V2 version for both the Tall and Tallest sizes. These versions are thicker, reinforced for stability and also reduce vibrations for when the printer is printing fast, especially on small objects. Has much less vibration than the older versions which I have since removed from the download files.