Snake skeleton model with articulated joints that prints as one whole piece.
Why does it have a top hat? I'm fairly new to modeling and I kept trying to get it to print without supports but wasn't happy with how it was looking. So eventually I got frustrated and just added a hat.
Understand that this is a difficult thing to print. Lots of tiny pieces printed across the print bed. If your bed isn't level, your print temp is off, or you're printing too quickly, this will turn into a mess fast.
I printed it at 100 microns, 30% infill, 4 bottom and top layers, no support.
I also slowed down my print speed a bit.
Once your done printing, be extremely careful removing the piece. The little spines break easily and some of them my be stuck together and need to be broken loose.