This spool holder has been modified to fit the spools for the Sculpto 3D printer.

Print the Filament Holder and any axis.
If you are printing on a Sculpto that has issues printing near center use the OFF CENTER file. (OFF CENTER diameter: 165,08mm vs. normal diameter: 146,60mm)

There are three different axis:
With centering groves for 500g spools
With centering groves for 1000g spools
Without centering groves

I was asked to also make a thicker version, the files for this have been added and prefixed with 90mm.
Please note that the axis for the 'normal' (80mm) version will not fit the 90mm. The axis from the 90mm will however fit into the 'normal' version but will be 10mm longer than needed.
The holder for the 90mm version has been rotated 90°, with the added width this means Sculpto owners need not fear the center with this version.

Sculpto

Yes

No

Normal

Supports are not needed!

If your print has 'strings' from the printer moving from one part to the next use a lighter and trace the outside of the holder. This will cause any thin 'strings' to melt with the figure.

To make sure the holder does not slide around when the spools become half-empty attach the holder to the surface with sticky fix (in Denmark known as 'elefantsnot' or 'lærer tyggegummi').

Items also available on tinkercad:
Holder: https://tinkercad.com/things/gb6MH3uPAid
Axis (no groves): https://tinkercad.com/things/jSzAKrRjpgO
Axis (500g sculpto spool): https://tinkercad.com/things/j2YccvuPac8
Axis (1000g sculpto spool): https://tinkercad.com/things/053cbgNTLwM