A simple flat mount to replace the windscreen suction mount of a TomTom Go 500 satnav. Instead of sticking your satnav to the windscreen, this mount will let you attach the magnetic TomTom dock to any flat surface in your car.
Just print it with a small brim, then carefully pull the ball-and-socket joint of your satnav dock apart. Push this into the socket and then stick it to the appropriate flat surface.
And just like that, your satnav is now closer to your fingers, and you still get to use the original magnetic charging dock.
If you live in a hot country, or plan on sticking this near a heater vent, you probably don't want to use PLA (and also consider whether your satnav will like being cooked too!).
Obviously rotate it the correct way up in your slicer!
Doesn't need supports, but a cooling fan on your extruder is highly recommended to prevent the fairly small stalk and ball from deforming.