Loading
ShipwreckedMonkey

An Open Source Beard Comb Tool

by ShipwreckedMonkey Sep 22, 2016
Download All Files

Thing Apps Enabled

Please Login to Comment

When slicing with Cura at coarse quality (0.4mm) with the CR-10 profile, the object is sliced so that the flat bottom is not the first layer. Instead, the only part that gets printed as the first level is the teeth. The rest of it is printed as the second level, which doesn't stick to the bed very well, and before long warps up. The fix is to rotate the object a little, and then use the "Lay flat" button, which will properly place it on the plate.

I printed this with a brim, and will probably be reprinting with a raft. Those teeth are just too difficult to clean up otherwise!

By far the greatest thing i have ended up printing... thanks so much!!!

FINALLY!! haha great design!