Loading
LoboCNC

Print-In-Place 12 Drawer Jewelry Box

by LoboCNC Oct 3, 2016
Download All Files

Thing Apps Enabled

Please Login to Comment

wow that is so usefull, realy usefull and awesome thing!

Thanks for the neat design. Printed in place, appeared to turn out well on Ender 3. However, my posts snapped at each drawer section so will print the base with posts and try to rescue. Drawers and base and post feel solid and printed well, posts seemed flimsy by comparison. Will recheck slicer settings (cura)

Your instructions and data are SO clear... Thanks loads for being considerate and thorough! THUMBS UP!

Thanks! I do wish Thingiverse would prompt for more printing parameters than just "supports", "resolution" and "% Infill". Any halfway detailed design with thin walls and/or gaps need more detailed slicing specifications.

you do have epmty room to writh what u wnat ...
why not writh it there....
btw very nice work.... :-)

Worked!
Printed on a CR-10
Cura 2.6.2 said 14 hrs, actual 18
Easy to free up the hinges though the bottom drawers were sticky (the printing of the base was a bit off under one drawer, my set up fault.)
Marvelous, practical little creation to inspire a young 3D designer to modify to her own eye.
Thanks!

Hey thanks! I'm glad it has inspired you.

I will say one simple advice
If you want it to be made with the less support and accessible by the majority of people heres, you must have to make all the parts separate ;)

Done. I've added the files for non-print-in-place drawers, base and top.

BTW, the original print-in-place version also prints without supports.

Good Lobo Work like always... i will try it soon :)