Endstop mounts for Kossel V-slot printer.
Remixed of Ultibots Kossel 250 V-Slot 3D Printer endstop mounts.
Works with metal corners.
These raises the max build height by 5 mm, compared with the mounts included in the kit for my printer. I leave the connectors on the microswitches pointing up on each side of the pulley. The middle connector pin cut of.
I raised the holes for the switch and cut out 5 millimeters to make space for the carriage. Also the bracket is now 6 millimeters thick on the switch-side instead of 5, to make room for the wire connectors on top.
Test your endstops and make sure your carriages can still reach them before starting calibration.