Cut lines are included in the model. I printed the box in PETG vs PLA to resist the heat generated by the heat gun, and it seems to work fine. The vacuum hose hole is 35mm. Trim or fill it to fit your vacuum hose. Use a 4" bamboo hoop to hold the polystyrene sheet. Polystyrene sheet used here is 0.02" thick.
Tip: see the end of my video (link below) so see how I installed the canopy on the frame. I used the flight controller's screws to bolt the canopy down to the frame. It works much better than using the side tabs.
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.