This is an HDMI output connector mount for the Amiga 600. It can be used to make the HDMI port of the Vampire 2 accelerator board available externally.
To use it you will need to remove the RF modulator from the main board. The mount holds an HDMI to HDMI adapter to connect a short HDMI cable to the Vampire board internally and makes the other side accessible externally. It is held in place by two screws that go thru the holes in the PCB that held the RF modulator.
The following components fit:
- https://www.amazon.de/gp/product/B00C1G0NIU - HDMI-to-HDMI adapter
- https://www.amazon.de/gp/product/B00975USLU - short and flexible HDMI cable with small connectors. It is not in the way of the floppy drive and also larger expansion cards like the A603 still fit in. (You will however still have to remove the outer plastic case on one connector in order to keep the IDE controller port accessible - the connector contains a 2nd smaller plastic case inside that still gives it enough stability)
- 2x M2x30mm screws / nuts