Landing gear for the KingKong 260 quadcopter. This raises the craft about 18mm higher than the stock landing gear so it is better in grass.
The stock landing gear would easily fall off. This is bolted on by the motor screws.
I made it in two parts to make it easier to print (no supports) and also you have the choice of using the base or not.
If you use the base, then simply glue the two parts together with epoxy.
I found that the stock screws (7mm excluding head) were just about long enough to screw into the motor through the base, but I replaced them anyway with some 10mm (excluding head) M3 screws.
I used Google Sketchup. I have included the Sketchup files.