I had trouble getting a good distance and height for my PS Camera when using it with my PSVR so I bought the cheapest floor lamp at IKEA* and designed this mount for it (which clamps around the rod). I don't use the lamp part/lampshade, the base and the rod acts like a stand for the camera.
I also designed a cable clip for attaching the camera cable to the rod.
That way I can easily adjust the position, distance and height.
*The floor lamp is called NOT and cost about ~$8
- Exacto knife
- Wet sandpaper (1000> grit)
- 2 x M4 bolts and wing nuts
EDIT: Added a link to the floor lamp, thank you tgraves226!
40% (100% for the cable clip)
| Filament: Flashforge PLA | Shell thickness: 1.2mm | Bottom/top thickness: 1mm | Print speed: 50mm/s | Printing temp: 210C | Bed temp: 60C | Slicer: Cura (15.04.6) | Print time (total): ~2.5h in total |
Trim the edges, mount to rod using two M4 bolts and wing nuts/regular nuts.
Trim the edges, attach to cable and then clip it on to the rod.