If you like my work I hope you'll consider supporting me on Pateron: https://www.patreon.com/3DPrintingProfessor
Subscribe to me on YouTube: https://www.youtube.com/user/mrjoesays
In my opinion, MrJaws (and MrAllagator) represent the best thing about having makerbots in the world: That you can mave something functional with an artistic side. That blend of engineer and designer.
However, MrJaws was, to me, a little TOO much artistry, speaking in terms of volume. So I decided to make a version that was just as much shark, but heavier on the jaw.
Leave me a comment if you would like me to do the same with the alligator.
The STL here is 2x bigger than it needs to be, which is okay for chips but not as good for smaller things. Scale it down for the job you're doing.
Print and clip.
Then leave a picture and a comment and check out my other designs.
WIP until someone with a printer tells me this'll work (tho I can't for the life of me imagine why not).