A touch replacement for a german shutters belt. You can drive your shutters via WLAN (MQTT) or over the touch wall switch.
cut the 4 buttons from the TTP224 and solder a wire on the caps. You need 4 wires to the SonOff Dual (Vcc, GND, Button1, Button2).
You must jumper on TTP224:
AHLB - Direct mode, CMOS active low output
SM - Single key mode
TOG - optional if it should be used as a switch and not a push button
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.