Remixed from the very nice model by powermos ( http://www.thingiverse.com/thing:1565411 )
Just worked on the bottom shell, to add four extensions on the edges, so that the case can be mounted on a plate or vertically. Top shell is the same powemos did.
This might be useful for some DIY project in which you can use the unexpensive OrangePi board for automation (e.g. I am working on a email controllable thermostat solution and need to place it on a wall beside the boiler)
Sketchup model attached for any customization need
No need for supports, just make sure the flat part is on the bottom, should simply print fine.
I used Simplify 3D as a slicer: 0.2mm layer, 2000mm/min, 15% infill.
It took about 1hr and 20mins for the bottom shell to finish on my Creatr HS
I used Sketchup v8 to customize powermos' original model, then fixed filpped triangles in Simplify 3D