Lens Cap

by walter Nov 25, 2013
Download All Files

Thing Apps Enabled

Please Login to Comment

Comments deleted.

Thx Walter, these printed magnificently, and is a very nice design indeed.
Even though I printed almost flawlessly, how did you manage to pull that super tidy bridge gap that we see in the penultimate photo without support?
I tried balancing bridge speed and flow, but not to your kind of result.
Best regards!

Tried printing with Hatchbox ABS, sliced in Simplify3D and unfortunately the slider mechanism fused together. Really neat design and prints very cleanly.

If you want a 58mm version, scale it up in Meshmixer. I had a successful fit-up at about 1.0086 X/Z scale and left Y as 1. (Meshmixer seems to label the coordinates strangely at times.)

You could probably just scale it in Simplify3D as well.

I would love to try to print this if there was a 55mm version available.

PLA is too brittle for this

PLA doesn't work well at all.

Is it possible to add 58mm and 55mm ?

Works fine here with PLA! 0.1mm layer.

This does not complie into gcode on ReplicatorG software. It creates an unknown error and therefore can not print.
Corrupt file?