This is a Remix of the C270 Tripod mount and the MP Mini Tripod Camera Mount.
This will allow you to add as many arms as needed, to get the desired height/angle for your print. It also makes for better timelapse photos, as the print moves with the camera. This still may need some adjustments with where the arm fits into the triangular base. The first attempt was a bit tight. The uploaded version should make up for that, But I have not printed it to test it.
Note: The focus ring should be printed at 98%-99% scale. The first one at 100% was too loose fitting. 98% was a nice, snug fit.
Depending on the orientation you mount the clips, you may need to add nuts/washers for spacing. I used 2-M3x20 screws for the mount to bed clips with 1 nut and washer for spacing and 1 nut to secure it on each clip. The arms use M3x20 screws and Nuts. The top arm that mounts to the hinge needed an m3x25 if I recall.
Scale Focus ring to 98 or 99% to get a better fit on the camera's lense.
Also note, Not sure if it is part of the STL, but the "tripod arms" when imported in My S3D, were .2 above zero on z height. Double check this is flat on the bed, so you are not printing in air.