A stiff and stable sensor supoort for the Aner A8 and a LJ18A3-8-Z/BX or any other 18mm diameter sensor.
It is located on the right side to enable better acess to the extruder and placed so that a colision with the heat bed cable is avoided. The disadvantage is that it is located further away from the sensor than those located at the fan.
For autolevel instructions see:
Extended fan duct:
My Marlin RC8 setting (should work for Skynet also)
// Travel limits after homing (units are in mm)
#define X_MIN_POS -33
#define Y_MIN_POS -10
#define Z_MIN_POS 0
#define X_MAX_POS 220
#define Y_MAX_POS 215
#define Z_MAX_POS 240
// Set the boundaries for probing (where the probe can reach).
#define LEFT_PROBE_BED_POSITION 35
#define RIGHT_PROBE_BED_POSITION 200
#define BACK_PROBE_BED_POSITION 170
#define FRONT_PROBE_BED_POSITION 20
#define X_PROBE_OFFSET_FROM_EXTRUDER 65 // X offset: -left +right [of the nozzle]
#define Y_PROBE_OFFSET_FROM_EXTRUDER -36 // Y offset: -front +behind [the nozzle]
#define Z_PROBE_OFFSET_FROM_EXTRUDER -2.90 // Z offset: -below +above [the nozzle]