Loading
h3lpless

Jeep Wrangler Hood support/stand clip

by h3lpless Nov 23, 2016
Download All Files

Thing Apps Enabled

Please Login to Comment

Worked perfectly on my 04 Ford Escape!!!

It didn't fit into the slot on my hood (98 TJ) . However, the clip fit the rod just fine. I basically need to increase the size of the plug that goes into the hood. Do you have the original design files that you can share by any chance?

I did a little more digging and discovered that there are actually 2 parts needed - I attached a photo - unfortunately my design skills are not quite up to this task (yet.)

I have a 98 tj that has never had a hood prop holder since Ive had it. I printed this off but the hole for the holder on the hood is way bigger than the mounting side of this. In the picture it kindof looks like there is a rubber grommet or something holding it in. Is this the case or should it be a direct fit into the hood without anything else?

What type of plastic was this made from? I'd think PLA might be too brittle for pushing into the hood, as well as the push/pull of the rod?
My stock one broke one of the sides, and this will be absolutely perfect to replace it with...

I need one for a JK, anyone know where I can find it?

Do you have the original clip still?

Sorry for the delay in my reply. Yes, I still have the original.

Just what I needed! Thanks :)