I was not able to adapt the model, so I've designed it from scratch.
1) on the right side of your power supply it is a screw hole 3 mm, the cover uses that one
2) on the left side I added the support for an additional screw. You will need to drill printer's side with 3.5mm, I did not get long enough bit for that, so I used a oven headed nail to burn the hole through acrylic glass.
Notes: optimized for no support print.
2016/01/24: enlarged for 5 mm to fit power-socket with 2 screws.
2016/01/30: printed and installed my latest model, looks great!!!
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.