This is another Peppa Pig toy that I made for my daughter.
Everything was printed on white PLA, painted with acrylic and finished with two coats of laquer (water based).
You will find two versions of the car body (Short and long).
Printing & building tips:
Enable supports for the car body and back seat.
You might need to sand the body a little bit so shafts can fit in.
If you want wheels to run properly, try smoothing the wheel hole with a dril bit and sanding the shaft.
Insert the wheel before glueing the shaft to the body. Be careful not to glue the wheel or it won't run!
I've Glued every part with cyanoacrylate.
Everything was designed using 123d Desing. I've included original files.