Loading
JohnnyTheOne

Adjustable fan duct A6

by JohnnyTheOne Dec 1, 2016
Download All Files

Thing Apps Enabled

Please Login to Comment

Nice, but not working well, still cooling on one side

In what Position you have printed it?

during printing of this fan the couple part of the fan failed while printing the other part of the fan dit just fine.
is it possible for you to upload the file for just the couple. it would be a waste of time and materials if i neet to print everything again/

I will also upload it separately

My question is, how did you install sensor to anet a6? did you change the board?

No it's the same

does this fit with anet a6 ?

This is for A6

It is a nice design, but sorry to say it is useless. It does not fit the nozzleposition of the A6 at all. THank you for your effort.

Its intended as written in description. It's built to use it with the autolevel fan bracket

what is the autocalibration thing you use?

the yellow thing next to the struder

what should the wall and top/botton thickness be ?

Thickness top, wall, bottom 3x

When I printed this part, the nozzle is not centered in the ring like in your picture. I have an Anet A6 and it seems like your STL is a different version than what is in your first picture because the STL file has the ring moved to the right when looking from the top down.

Can you please upload the version that has the ring centered on the nozzle?

yes, I will make an A6 and A8

Did you print this in PLA or something else? How is it holding up? How much did it improve your print quality?

Printed in PLA Recommend to print in ABS for durability. It improve +/- 50% the print quality