Yet another fidget spinner, only faster! As a guy with short fingers, available spinners were not so good to everyday use. Also, there were few asymmetrical options, which I prefer. My first try on this was very good (http://www.thingiverse.com/thing:1846220), but I found it a little too slow after some time. Then, I came up with this new design, Hope you all like it.
Use 22mm ballbearings (number 608)
Better with the caps (make them colorful)
no need for supports
50% infill. ABS or PLA, it doesn't matter
Please, share it if you print it.
If you print in ABS, sand the pieces and cover them with CA glue. They'll shine beautifully.