Tevo Black Widow right hand side heater 40 mm fan cooler for Regular or Vulcano E3D V6.
The purpose of the right hand side placing of the fan is double.
1] It is not blocking the nozle view.
2] The air is leaving from the left hand side into the open. If the air was conducted to the rear it bounces on the black X plate and can reach the nozzle area.
We are now on Version2 where we made some room for the filament clamp design from http://www.thingiverse.com/thing:1922880 by Gary K.
For optimal usage it can be combined with http://www.thingiverse.com/thing:1937134
We also turned around the mounting of the BLT and the springs so you can adjust them more easily from below.
Version with lower BL-Touch bracket is for the Vulcano version.
Designed to be used with the springs that come with the BL-Touch.
The use of the springs gives easier adjustments.
Small tab in front is to mount a 5 mm white LED which shine on the nozzle.
No extra hardware needed.
I printed in PETg with 0.4 mm nozzle with support on heat bed as this is the only filament I had.Can be printed in PLA too...........
Print as is with supports on heatbed.