Have you had your servo mounts come loose while on the trail. The fix is to take the servo off, then the plate ... then finally tighten the servo mounts then put it all back together again. What a pain to say the least! With this one piece servo plate you will have a stronger plate and no worries of the servo side mounts going loose again.
Note that the part should be rotated so the servo mount screew holes are on the build plate. I desgined the part to be printed this way. The shrinkage of the holes are compensated for when printed in the rotated direction.
If you don't have a 3D printer these are available for purchase on my website here
After loading STL file rotate 90 degrees so the face that the servo screws to to is down against the Z build platform. The whole are designed for shrinkage with the part in a specifc orientation. I suggest using 2 shells at least.