So here i'm explaining this tool.
This is my personnal turbine i will use for several things, i'm actually a welder and will build a forging table but it need a constant air in the fire hole so i decide to build this Turbine. Don't worry about the heat, i'm not dumb and there will be a prolongation tube for not being close to the fire hole ;)
Anyway i wonder myself if i would not use it to suck air out of my printer box because it smell too much plastic etc etc .
SEE IT IN ACTION HERE :
So ! This is my personnal air blower, you will personnaly need
-->M4 Bhc/Chc/H 20-30 mm long screw
-->One little ball bearing 11/4.8 with 5mm thick (you can print a shaft or replace it with M4 shaft it will work fine too don't worry)
-->M4 nut or Counterlock nut
Not too much required huh ?
I also published the size if you want to make your own adaptable air system or tube so you have the quotation in millimeter
For the motor, prefer 12V motor with high speed ;)
The reduction is about 42/8 It multiply the motor speed by 5.25 if there is no friction.
Depending on the motor it can blow (for me) +-20L of air / min
I print this with a little print bed : 115/115/115 mm
This is a work in progress as long as i can modify it if you have any request about it.
Don't hesitate to drop a like or subscribe ;)
If you wanna see more or want to give me an order/suggestion of project you can go on my Facebook for request ect ect;
Print bed required : 115mm Larg / 115 mm long / 60mm heigh
Layer heigh recommended : 0.2 - 0.25 (but you can with 0.3 but it will look crappy and will surely cause friction)
Plastic recommended: ABS / PLA are fine