Loading
Pandariot779

PokeGo Plus Backplate Mod with 18mm band

by Pandariot779 Dec 16, 2016
Download All Files

Thing Apps Enabled

Please Login to Comment

hey nice design, i want to modify the go plus with an litium polymer akku and charging bord can i have the files to make an bigger back plade ?

Could this be modified so it fits Apple Watch band, looks like the band on my Apple Watch is 23mm.

Nice design, man! Can I have the files for modifying it? I'm making a project to add a switch button to my Go+ and I found that you design is the most accurate for the inside.

Printed the modified back plate, Couldn't get the strap through the weird cut out section. Also, the stock screw isn't long enough to close it, I had to take my soldering iron to it to deepen and enlarge the hole. Once I got it tight, rest of chassis was loose.

its a tough model . i will think up of something. the original idea was to try and get a wrist watch strap to fit it but ive been having trouble getting the piece to be printer friendly. i was hoping the modified version will act as clip.

Aye, having that much off the build plate is an issue. Perhaps have the strap band either slide in or click in place? The set in two pieces prints well, but then has a weak joint at the point of most stress. The screw hole is still a major issue.

Nice to see fast forward of how you designed this project

thanks, i would like to make more videos

Need it slightly remodelled. Printed in ABS and the band holders just snap under any pressure. can you remodel with wider/beefier bands. I'd rather not re-invent the wheel by doing it myself. other than that it fit perfectly after a bit of sanding the inside.