Loading
DRPrinting3D

Arduino Uno and LCD keypad enclosure with buttons.

by DRPrinting3D Dec 18, 2016
Download All Files

Thing Apps Enabled

Please Login to Comment

was getting ready to build a case for this when i decided to look here first.Case was perfect for what i needed.I had a cheap China LCD that had the buttons just a little bit off,it still worked like a champ.Many thanks for the effort in designing such a great enclosure.

Very cool. A couple of suggestions:
1) To have a version with enough room for the LCD/Keypad where 90 degree right-angle pins are installed in the top and bottom expansion holes. (Basically there are two sets of pins on the bottom edge (a 5 pin and a six pin set) and 1 set on the top edge (7 pins). For some projects it is required to use right-angle headers to keep the profile as low as possible (and they need to be mounted on top because if they are installed protruding from bottom the LCD/Keypad cannot be mounted directly on top of the Arduino.
2) A version big enough to fit over an LCD/Keypad that is mounted on top of an Arduino Mega 2560... Of course this would require the bottom half to be bigger.
3) A version with both of item 1 and item 2 above! Lol!

In any case, this is a very cool design. Great Job!