These items create a base for the well known Gotek USB disk drive emulators used in Amiga 600 computers.
There is no need to cut the Amiga computer case, and the buttons and USB port can be accessed and used easily.
Also the disk drive button port will be covered so no hole is being left.
New updated version which supports FlashFloppy - Oled displays: https://www.thingiverse.com/thing:2745095
I've used Signal White ABS filament from MakerPoint with temperature setting 250/90 deg. C (heaterblock/bed).
It takes about 5 hours to print and uses around 3.7 meter of filament at 50% infill and 0.1mm layer height.
File off any unwanted filament support, especially when placing the 7 segment display unit
Both items were created using OpenSCAD