Cases for the FrSky XM and XM Plus receivers to provide a little more protection than the clear shrink-wrap that is installed from the factory. This is a simple two piece case which allows access to the BIND button and connections. I'm using the XM with my RX2SIM to allow wireless simulation/practice with my Horus.
Files have been updated to support the 90 degree header connector.
I don't have an XM Plus, so I haven't verified the fit to an actual receiver.
I have made one final edit on the XM Plus case based on feedback and now feel it is finished.
Print in a transparent/translucent material to be able to see the status LEDs inside. I used a clear PETG+. Side walls are 0.9mm thick assuming an extrusion width of 0.45mm (0.4mm nozzle). Best printed when laying flat on the print bed, not the orientation as it comes out of Fusion 360. Supports are optional for the connector window.
It will require a couple of spots of CA adhesive to attach the lid to the body. Also, the antenna end of the lid will require a little sanding for the lid to fit the body flush as the height of the end wall is determined by the printer's layer resolution/accuracy.