Raspberry pi 7 inch screen case (remastered)

by Piper3D Jan 2, 2017
Download All Files

Thing Apps Enabled

Please Login to Comment

Hi alexb123. Could you please describe your process for remastering luc_e's Pi display case to incorporate the raised edge? Thanks Carl

Hello Carl,

I have recreated case in FreeCAD from scratch and printed several copies to make sure screen fits.

Hi Alex. Thanks for the response. I'm contemplating using your front section, I like the protective lip. However I want to add a multi leaf pin joint to the middle section of luc_e's thing; which would then be mounted on a baseplate. In the process I’m hoping to flip the screen the right way up, to improve the viewing angle, but still have access to the ports and allow enough room for an additional RJ45 connector. I have a commercial (possibly official?) display case, but the bottom edge of the display rests on the table surface. So I was hoping that you had somehow imported the .stl and turned it into a model, but clearly not. Looks like I’ll have to 'trace' the part in FreeCAD.