D20 RGB Lamp
by Colecago, published
Liked ByView All
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.Print Thing Tag
3D Printed, Arduino driven, RGB D20 Lamp. Full writeup here:
Arduino - https://www.sparkfun.com/products/11113
LEDs (x5) - https://www.sparkfun.com/products/13282
Power Supply - https://www.sparkfun.com/products/12889
Barrel Jack - https://www.sparkfun.com/products/10785
Push buttons (similar, x2) - https://www.sparkfun.com/products/9190
D20 Translucent - http://amzn.to/2hLp1iy
Files are now rotated and should be flat to the bed.
Base gets glued to the electronics compartment using super glue.
Push the pushbutton leads through the switch backing, push the backing up into the electronics compartment with the buttons through, and hot glue it in place. You can wire leads before or after they are in place if you are careful.
I wired ribbon cable to the LEDs and pulled the cable through the holes and put a spot of hot glue where the circuit board sits on the plastic to hold it in place.
Then the electronics can be all wired together.
Power and ground to all the LED's, one digital output pin from the Arduino into the data in on the first LED, then chain the data outs to data ins of the other LEDs, the last LED's data out is not used.
Put ground to one side of both push buttons and then wire the other side of them to two of the digital inputs on the Arduino.
I did add a capacitor to the 5V line in from the barrel jack and then wired the power from there to the Arduino and all the LED boards, you could probably chain the power and ground board to board, but I had the room and didn't want any lights dimmer than another from voltage drops in the wires.
Upgrade this Thing with Thingiverse AppsCustomization
Edit, personalize, or revise this ThingTools and Utilities
Repair, slice, or enhance this Thing
D20 RGB Lamp by Colecago is licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is not allowed.
Show Some Love
Say thanks by giving Colecago a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure Colecago would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).