You'll probably know this issue: The desk is full! So i've created a mount to place the arc reactor on the wall. Because I want to place it in the corner, it must pivot to get a nice angle. I use a GoPro arm and a small extention piece to make this happen. Offcourse you can print it, but it saved me some time. Can also be used as a normal stand. No glue required. The cap just clicks in place (in my case). I have used two bolts and screws, 20×4mm and 16×4mm. The wall version is 3mm thick and has a hole in the baseplate. The stand version is 2mm thick and has a smooth surface.