This is a LED desk lamp. My intention was to create a lamp with less support material and which is easy so assemble.
The cover parts have the purpose to produce an indirect lighting. They can be modified with different patterns to create a new look.
It´s possible to glue the parts, but it´s not necessary. I reduced the thickness of the connection because it was a little bit too tight. I think i printed the parts a little bit too fast, but with the thinner connection it fits good. The foot is formed like the root of a tree and i created also a little container to put some sand in it to make the foot heavier, but it´s not necessary for a good stand on your desk.
- 3 outline perimeters
- 5 top and bottom layers
It´s not necessary to bolt or stick the foots to the desk, but it´s necessary to stick some piece of rubber pad unter the foots. That increases the stability of the construction immensely, because then the foots can´t slip apart. When the foots are stable at the ground, the strain is consistent over the profile.