Ever open up your random small part container only to find you are down to your last M3 bolt, however when you try to grab said bolt and your greasy ape fingers just push it into the corner of the drawer resulting in many a dirty word to emanate from your face flappers? Dread not my fumbly friend! Introducing the Last Bolt Removal Assistance System, our engineers have slaved over many an unpaid holiday to create a drawer with no bottom corners, only radii. That last bolt is now attainable! We believe with this ingenious creation all of the worlds problems can be solved. (With the exception of most of them.) Tolerances are perfect unscaled, the drawers fit tight enough to stay in but not so tight that it's difficult to remove. There are cutouts in the rear to mitigate the effect of air pressure for an easy slide. Enjoy!
I printed mine at 5% infill which worked fine, however your results with that little infill may vary. You will need one of each part except the SmallDrawer of which you will need 2.