Original design was is good, however sometimes (maybe because of my printer) caps were too loose. I redesigned the cap from scratch using FreeCAD. I modified a bit wall, base thickness and increased inner cylinders diameter. Now every printed cap fits my XT60 perfectly (I have 3S, 4S Tattu 1,3-1,5mAh).
I would recommend to try different caps from thingiverse becasue I noticed that XT60 from different manufacturers fits in these cap differently.
I uploaded three kind of cap files:
- Storage - with letter "S" - XT60_S_cap.stl
- Full - with letter "F" - XT60_F_cap.stl
- Blank - without letter - XT60_cap.stl
0.8mm top and bottom solid thickness
1.6mm wall thickness