I needed a wall mounted headphone rack for my Audio-technica headphones, but I can not put nails in the wall so it needed to use command strips. I designed this to use two medium sized strips. The strips do peak out from the bottom a bit, but it is easily trimmed. Sorry for the potato camera, I couldn't be bothered to get out my good one.
The entirety of this project used PLA plastic. I used a skirt for the base, and an 8 mm brim for the hanger. It could probably be brought down a bit. I rotated the hanger onto its side to print it better with less support.
The support material needs to be taken off and the key-way needs to be cleared of any excess material