I print a High-Resolution gear1. I print parts with normal reslution but that one.
This is a list of electronic components(in Japanese).
You have to create a circuit as shown in the figure below.
Please see this page that is assembling instructions of the projector.
(Take the time to read)
I prepared both ai file for laser cutter and obj file for 3D printer of case. You can choose either one. ( I recommend using ai file.)
If you use laser cutter, the thickness of the board is 2 mm.
I confirmed 3-bladed shutter isn't need, so I don't upload it.
You need to prepare a ready‐made loupe and schafts.
I use (x15 Lens diameter: 20 mm / maximum diameter: 31 mm) ETSUMI E-203 (in Japanese) and Tamiya 70105 3mm shaft
You have to prepare film. The film long is 67 frames.
If you don't have 8mm film, you can create original film using OHP sheets.
This software creates film sheet from serial number image.(Drag and Drop)
Then, print it by 2d inkjet printer, and cut it using template.ai by lazer cuttor.